If Windows does not boot from the USB flash drive after showing the Windows logo, you may have to run the following command to tell the firmware to boot the Windows installer from the USB flash drive. Select EFI volume in the startup selector.Insert the USB flash drive into an available USB port on the Mac.To inject the drivers, the Mac must be booted from the USB flash drive. HOW TO DOWNLOAD FILES TO USB FLASH DRIVE MAC DRIVERSThe $WinPEDriver$ folder is important because it contains the drivers for Windows to boot successfully from the USB flash drive and the hardware on that Mac. Once the flash drive has been created, it should look like this: On the USB flash drive, open the $WinPEDriver$ and remove the IntelMEI folder. HOW TO DOWNLOAD FILES TO USB FLASH DRIVE MAC INSTALLTo install Windows, make sure that the drivers are valid, and restart the installation” message. HOW TO DOWNLOAD FILES TO USB FLASH DRIVE MAC DRIVERThe 2018 MacBook Air (and potentially Macs after that) cannot load the IntelMEI driver and give a “Windows Setup could not install one or more boot-critical drivers.AutoUnattend.xml provides the location of the $WinPEDriver$ folder to load the drivers during boot. If there is not an AutoUnattend.xml at the top level of the drive (as shown below), download AutoUnattend.xml, unzip it, and add it to the drive.Drag the contents of the Windows Support Software to the USB flash drive.Drag all the files and folders from the mounted ISO to the USB flash drive.To mount the ISO, double-click on the ISO in Finder. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |